Insta360 Motocykel U-Bolt Mount V2

After receiving the U-Bolt, use the two spacers to adapt your mount to a regular motorcycle.

The use:

1. Install the spacer into the U-bolt according to the clamping position and size.

2. Tighten the universal joint to the U-bolt firmly before use.

3. The attached pairs of pads consist of two sets of pads. Be careful not to lose them during disassembly, as losing the washer can cause the nut to loosen due to vibration.

4. The U-bolt can be installed on the motorcycle frame, rear pedal bracket, bumper and other secure areas. Always check that the U-bolt is locked in place with no rotation or play in the bracket when locked.

5. Driving is recommended only on smooth roads at a speed not exceeding 80 km/h (50 mph). Off-road driving is not supported.

6. Only Insta360 Action Invisible Selfie Stick is recommended to be used with this accessory. Do not attach any other accessories to the holder or selfie stick during use. Applying force to the selfie stick can damage the universal joint. This mount is not compatible with the Insta360 Extended Edition selfie stick.

7. When the motorcycle is parked outside for a long time, remove the accessories to keep it in the best possible condition.

8. Please use the accessories according to the installation method in this user manual, do not DIY. Damage caused by failure to follow instructions will not be covered by Insta360's warranty or replacement services.